6
1. Before mounting any blade on the saw, the blade should be inspected for any damage
which might have occurred during shipment, handling or previous use.
2. The blade collars and arbors should be cleaned and examined for damage before
mounting the blade.
3. The blade must be properly fitted over the arbor.
4. The blade shaft nut, which is a left-hand thread nut, must be tightened securely against
the outside blade shaft collar.
5. The blade must be operated within the specified maximum operating speed listed on
the blade.
6. If wet cutting submerge the water pump in clean water and open the water control valve to
provide adequate coolant (4 to 6 gallons per minute). Insufficient coolant could result in
severe blade breakage or diamond segment separation.
7. The blade guard must be in place with the blade collar guard closed when the saw
is running.
8. The operator should wear approved eye, hearing, respiratory, and head protection.
9. When starting the saw, the operator should stand away and to the side of the blade.
10. If for any reason the saw should stall in the cut, raise the blade out of the cut and switch the
power off. Check outside blade shaft collar and nut for tightness. Inspect the blade for
damage. Before restarting the saw. Use caution when resuming a cut. Be certain that the
blade is in alignment with the previous cut.
11. During cutting operations, do not exert excess side pressure on the material as a
method of guiding. Do not force the blade into the cut by lowering the blade too fast
or by pushing the cutting table too fast.
You Are Responsible For Your Safety!!!
Machine Lifting Points: Only lift machine by the approved lifting points.
Lift Here
Lift Here
