29
Figure 6-1: Side Support Bracket Location
Figure 6-2: “U” Shape Bracket Location
• Failure to follow the above removal procedure may cause the user injury or
damage the plastic Dust/Water Collecting Pan.
Optional Dust/Water Collecting Splash Guard Assembly, Optional Stand
The Dust/Water Collection Splash Guard Assembly is an optional accessory that is used to help
control the dust (when used with the optional dust control kit) developed while dry cutting or to
control the amount of water splashed behind the machine (when used with the optional wet cutting
kit). The following procedure is required to install the Optional Dust/Water Collecting Splash Guard
Assembly:
1. Place the Dust/Water Collecting Splash Guard on to the rear of the machine. The inner sides of
the Dust/Water Collecting Splash Guard fits inside of the vertical up rights. The bottom of the
Dust/Water Collecting Splash Guard has a flange with a rubber gasket glued to it, this flange fits
over the outside rear of the water pan.
2. Align the holes in the Dust/Water Collecting Splash Guard with those in the machine’s vertical
uprights and those in the water pan.
3. Attach the one (1) Side Support Bracket to the inside of each side of the Dust/Water Collecting
Splash Guard with the hex-head bolts and flat washers (see Figure 6-1: Side Support Bracket
Location). NOTE: The Side Support Bracket will hold the Dust/Water Collection Splash Guard to]
the vertical upright. This figure is shown in an exploded view for clarity.
4. Place the smaller “U” shaped bracket over the inside of the water pan’s rear flange (see Figure
6-2: “U” Shape Bracket Location). NOTE: This figure is shown in an exploded view for clarity.
5. Align the holes in the smaller “U” shaped bracket with the holes in the water pan’s rear flange.
6. Place one (1) Carriage Bolt into each of the smaller “U” shaped bracket holes.
7. Align the larger “U” shaped bracket holes with each of the threads of the Carriage Bolt and attach
With the wing nuts.
Side Support Bracket
Small “U” Shaped Bracket
Optional Folding Stand part number 235001
[
Attach the Block Buster
Mini to the stand with
the wing nuts supplied
with the optional stand
