Northwestern Bell Excursion 36288, Owner'S Manual

Page: 42 / 55

42 041604A-1
7. Press “SKIP ” button to increment or “REPEAT ” button to decrement the minute in the
display.
8. Press “ TEME SET” button to confirm. You will hear “AM”.
9. Press “SKIP ” or “REPEAT ” button. You will hear “PM”. Press “SKIP” OR “REPEAT”
button again to go back to “AM”.
10. Press “TIME SET” button to confirm. The new day and time will announced.
SETTING REMOTE CODE
1. Press CODE button(on the base). Then you will hear the current setting, “one, two, three”.
2. Press and hold “code” button for about 3 seconds.
3. Press Skip
or Repeat button (on the base) to select the first digit you desired.
4. Press the CODE button to confirm.
5. Press Skip
or Repeat button to select the second digit you desired.
6. Press the CODE button to confirm.
7. Press Skip
or Repeat button to select the third digit you desired.
8. Press the CODE button to confirm.
You will hear the newly programmed 3-digit security code.
OUTGOING MESSAGE (OGM)
This is the announcement callers will hear when Excursion
®
36288 answers a call. The Excursion
®
36288
also has a default OGM(factory preset) which is active when there is no OGM present.
Default OGM: “Please record your message after the beep.”
RECORDING THE OUTGOING MESSAGE(OGM)
Outgoing Message(OGM) is recorded remotely on the handset. The maximum recording time is 30
seconds.
1. In standby mode, press the REMOTE button on the handset. The Excursion
®
36288 will prompt .
2. Press 3 button. The Excursion
®
36288 will prompt “Please record your announcement after the beep.