Supertow
II
Setup
Secure Clutch Cable to Handle
.
Locate keeper on lower left side of handle. Remove the
10-24 Screw and attach Clutch Cable using the tab on
cable housing.
Be sure Clutch Cable is on the outside of Throttle and
Brake Cables, then secure all cables (Except Clutch) to
handle with nylon ties provided with Throttle Cable down
left side and Brake Cable under handle.
Bottom View for Reference
The two bolts next to the engine pulley are belt
guides, that create a loop around the pulley
keeping the drive belt from engaging while the
engine is running and clutch is disengaged.
There are three pulleys on the bottom of the
unit: The engine drive pulley, the large
transmission and the small clutch pulley on the
clutch arm.
These pulleys need to be line
with each other.
The bolt on the left side of
Clutch Arm will need to be adjusted after the
first couple hours of use. If the Clutch Arm
drops down out of alignment, it will run on the
rim of the idler pulley and spin the drive belt
off the unit.
Shift Cable
Throttle Control
Lazy Susan
Release Cable
Clutch Cable
