10
NOTE: To install decorative pebbles, follow these steps. Have a capable adult help you.
STEP 5A
. While one person holds the glass panel, remove the two screws at the top edge of the
fireplace with a Phillips (+) screwdriver.
STEP 5B
. Together, carefully remove the front glass panel and set it aside on a clean soft surface.
STEP 5C
. Set the plastic shelf
(H)
onto the ledge in the opening at the front of the fireplace.
STEP 5D
. Arrange the decorative pebbles (
F
) on the plastic shelf in the desired position.
STEP 5E
. Set the front glass panel back onto the firebox.
STEP 5F
. Align the tabs of the glass panel with the holes on the top edge of the fireplace. Thread
the screws back into the holes and tighten them both with a Phillips screwdriver.
Installation for Metal Stand
STEP 6A
.Fix the
J1
and
J2
metal parts with screws
( I ) ,
in total two sets. Using screws (
D
) to fix
the two stand brackets (
G
) to the J1/J2.8pcs screws (
D
) will be used.
STEP 6B.
Put the fireplace on a soft surface flatly,see the drawing above,locate the bracket to the
bottom mounting holes,fix the baseboard with 8pcs ST4x10 screws
(D
)
Tighten each screw securely with a Phillips screwdriver.
Operation
Read and understand
this entire owner’s manual, including
all safety information
,
before
plugging in
or
using
this product. Failure to do so could result in
electric shock,
fire, serious injury, or death.
Power
Make sure the ON/OFF switch, located on the left side panel, is in the OFF position. Plug the power
cord into a 110~120 Volt 15 Amp grounded outlet (see
IMPORTANT SAFETY INFORMATION
on
J1/J2
I
D
G
D
Summary of Contents for 80-421S
Page 6: ...6 C ...
