Assembly & Initial Set-Up Instructions
–
REV. D
14 |
P a g e
Any Questions, Comments, Problems, or Parts Orders
Call NorthStar ProSHOT Product Support 1-800-969-7073
TOOLS REQUIRED:
9/16” SOCKET AND WRENCH
Torque: 27.2
–
34 ft./lbs.
STEP 2. LADDER RACK TO TRAILER ASSEMBLY INSTRUCTIONS
1)
Remove ladder racks from box. Be sure there are 4. There will be (2) front
racks and (2) rear racks.
2)
Locate (6) bolts and (6) nuts in the hardware bag.
3)
Using bolts and nuts form the hardware bag install front driver’s side and
passenger side ladder racks using bottom mount holes as shown in figure below.
4)
Using remaining (2) bolts form the hardware bag install rear passenger side ladder rack using upper mount holes as shown in
figure below.
5)
Install rear driver’s side ladder rack using upper mount holes as shown in figure below. Note you will need to remove and reu
se
existing nuts and bolts in place for mounting hose clips.
Note: If proper mounting holes were used for the front and rear ladder racks, ladders should
be close to parallel with the ground when hung.
