NorthStar EXPLORER 443D, Installation And Operation Manual

Page: 11 / 40

Press MENU once or more until the
Setup
menu
is displayed, then select
System
:
Language
Select the language for the displays. The options
are: English, Italian, French, German, Spanish,
Dutch, Swedish, Portuguese, Finnish Greek and
Croatian.
Tip: In case you can’t read the current language, the
language setting is found at the top of the system
menu.
Backlight
Select this option to adjust backlighting and
contrast controls.
Key beep
Enables or disables the beep when a key
is pressed.
3-1 Setup > System
3-2 Setup > Sonar
Press MENU once or more until the
Setup
menu
is displayed, then select
Sonar
:
Auto power off
Select to have the fishfinder power off
automatically every time the boat’s ignition is
switched off. This applies only if the display unit
is wired for Auto Power. See section 6-5 Wiring
Options.
Snooze Mode
This power saving option slows the sounding rate
(time between each ultrasonic pulse) to a user
specified interval from 5 minutes to 2 hours. The
fishfinder appears to turn off, however all alarms
operate normally. To return to normal operation,
press Power
button. Ideal to be used as an
anchor alarm.
Factory reset
This option returns all of the fishfinder settings
(except the language) to the default factory
settings shown in section 3 Setting up the
Explorer 443d/443df.
A warning box asks:
Are you sure?
Select
Yes
and press ENT to confirm.
Sonar (FISH 443df)
Select to enable sonar functions. Deselect if the
unit is to be used as a SmartCraft only display.
SmartCraft (FISH 443df)
Select to enable SmartCraft functions. SmartCraft
is only available with certain Mercury engines,
and requires an optional SmartCraft Gateway.
Beam
There is a choice of Narrow (200kHz),
Wide(83kHz), Mixed and Auto. For more info
about selecting a suitable frequency for water
conditions, see section 4-2 Single and Dual
Frequency Fishfinding.
Northstar Explorer 443d/443df Installation and Operation Manual 11