4.4.1.7
Restore all the factory settings
If you need to restore ALL of the radar settings (except trigger delay, heading calibration and whether
or not a heading sensor is installed) to their factory settings, do the following:
1.
From the main radar page, press
Page 1
.
2.
Press
Restore...
.
3.
Press
Restore factory settings
to return the unit to its state when it was shipped
with the exception of the following:
trigger delay
heading calibration
whether or not a heading sensor is installed
parking calibration
This function is used before performing manual tuning (see Appendix B) or at any time it's necessary
to restore the unit to a known state.
Restore the factory appearance settings
Appearance settings and manual settings can be restored to values that normally produce a useful
picture as follows:
1.
From the main radar page, press
Page 1
.
2.
Press
Restore...
.
3.
Press any or all of
Restore Auto
,
Restore Harbor
,
Restore Range Rider
, and
Restore Manual
to return to the factory appearance settings.
This completes the installation calibration. Note that the heading correction may need to be adjusted
slightly after the gain is optimized to provide a better picture.
Northstar 10 kW Radar Installation Manual
41
