Page 9 of 19
•
Attach the manual handle (#24) to the tube container (#19). See Figure 5.
Figure 5
The completed assembly is shown below in Figures 6 and 7.
Figure 6
Figure 7
Before Each Use
⚠
WARNING
•
Disconnect from air supply before changing accessories or servicing.
Before each use, prime the grease gun by following the Operation Instructions until grease flows from
the tip (#10a). If the grease gun does not prime properly, follow the instructions below for venting
trapped air. Inspect the overall condition of the grease gun and look for:
•
a damaged hose,
•
loose hardware,
•
misalignment or binding of moving parts,
•
cracked or broken parts,
•
damaged electrical wiring, or
•
any other condition that may affect its safe operation.
Venting Trapped Air
•
Remove the gun body from the tube container by turning counter-clockwise.
•
Install the manual handle to the tube container by turning clockwise. Make sure that the manual
handle is mounted securely onto the tube container.
•
Pull up and then depress the lever of the manual handle to inject a small amount of grease.
•
Repeat until enough grease is released.
