4-2 Installation procedures
297-2041-900 Standard 02.01 October 1991
Procedure 4-1xxx
M5212 ACD Set Installation
(continued)
Step
Action
2
Connect the four-conductor Teladapt connector at the coiled end of the
handset cord to the handset Teladapt receptacle. Connect the
Teladapt connector at the straight end of the handset cord to the
Teladapt receptacle in the base of the telephone. The Teladapt
connectors have a latch-tab which ensures correct alignment and
prevents the cord from being pulled out inadvertently during service.
Be sure that this latch tab is firmly snapped into place.
3
After you have connected the Teladapt connector at the straight end of
the handset cord to the Teladapt receptacle in the base of the set,
route the handset cord through the channel and past the restraining
tabs as illustrated in Figure 4-2.
4
If a headset is being used, connect the headset cord to the correct
Teladapt receptacle in the base of the set as shown in Figure 4-2.
Route the headset cord to the headset of applicable adapter as shown
in Figure
on page in
4-2.
5
Connect the line cord to the connector in the base, and push it under
the restraining tabs in the line cord channel of the telephone base.
(See Figure 4-2.)
6
Turn the telephone right side up and place it in the final workstation
position.
7
Print the directory number on the designation card. Remove the
number lens by inserting the end of a paper clip in the hole at the side
and levering upwards. Insert the designation card and snap the lens
with the card back into place.
8
Designate button labels for key designations.
9
Fold the labels and insert them inside the plastic button covers. Snap
the button covers over the movable keys, pressing down on each key
as required.
Ensure that the green button conver is on Key 1 - IN
CALLS.
10
Insert the line cord Teladapt connector into the connecting block and
verify that it has securely snapped into place. (Refer to Figure 4-3.)
- continued -
