Blade
Lower cost per
cutting operation.
Requires fewer
Blade changes.
Produces less dust
than Abrasive Discs.
All brickwork, reinforced
concrete and other composite
material.
Never use the Cutoff Saw with
saw blades, cutter blades,
brushes, carbide tipped, wood
cutting blades etc.
Water cooling is highly
recommended and
increases the Blade
service life.
We highly recommend that users cool Diamond Blades continuously with water to prevent
overheating that can cause Blade failure and potential injury and damage.
Proper Use of Diamond Blades
•
Ensure that the Cutting Blade rotates in same direction as the markings indicate.
•
Continually cool the Blade with water.
•
Keep the Blade sharp.
•
Always remove the Cutting Blade during transport.
•
Never run a Blade in the opposite direction of the indicated markings.
•
Never force a dull Blade or wedge a Blade into a cut.
•
Never let the Blade fall onto a work piece.
Dry Cutting Diamond Blades
Dry Cutting Diamond Blades are a new generation of Blades. While these Blades do not
require water cooling, they can still be damaged by excessive heat. When using these
Blades, we recommend that the user let the Blade cool by lifting the Blade from the cut every
30-60 seconds, allowing the Blade to rotate in the air for 10 seconds to cool, then resuming
work.
Starting Your Cutoff Saw
Before starting, observe the following:
•
Ensure the Cutting Arm, Belt and Cutting Head are in position; if they are not, the
clutch can disengage and cause injury.
•
Ensure you have firm footing.
•
Ensure that the Cutting Blade rotates freely.
•
Keep unauthorized individuals away from the work area.
Starting a Cold Engine
1. Slide the Stop Switch to the Run position.
2. Press down the Choke Lever.
Press in the Throttle Control and thereafter the Starter Throttle Catch (Release the Throttle
Control) and the Throttle is blocked in Half Throttle position. The Catch is released when the
Throttle Control is pressed all the way in.
13
