Installation
(
No Extensions
With 1 Extension
With 2 Extensions
B
tension
extens ion
extens ion pin
extension pin long end
insert into the gate
end
gate
extens ion
ru
er pa d
tape
screw
mounting cups to the wall with screws or
tape.
B
Measure width the opening.
, B,
to determine the correct installation.
Step 1
Step 2
Step 3
in figure 3A.
, as shown
Recess the gate at least 1" from the edge of the top stair.
Secure the gate and asten the mounting cups to the wall y aligning them with the olts with ru er pads.
Use dou le coated tapes or screw provided B.
IMPORTANT: Never install this gate without mounting cups! If installing the gate at the top of stairs, use
mounting screws and cups provided.
IMPORTANT—TOP OF STAIRS NOTE: Adjust gate stopper to prevent gate door from swinging over stairs.
Insert extension pins into hole on the outside o the gate rame. ote: the long ends o the pins go into the
gate rame, short ends go into the extension B.
Slip extensions over the pins.
Slide oth the upper and lower tension olts with ru er pads into the holes on the outside o extension.
Page 3
long
