Assembly and Initial Set-Up
12
a.
Rear Wheels
Have two people lift the back of the pressure washer by the handles while a third person
slides the wheels onto the Rear Axle. Fasten each wheel with a wheel retainer using a
hex wrench.
b.
Front Wheels
Have two people lift the front of the pressure washer while a third person slides the
wheels onto the Front Axle. Fasten each wheel with a wheel retainer using a hex
wrench.
Step 5.
Use a mechanical assist or two people to lift the assembled pressure washer off of the
pallet.
Step 3. Initial Pump & Engine Preparation
Prepare
Water Pump
Verify pump oil level
.
Note: The pump is shipped with oil.
1.
Verify oil level:
a.
Remove shipping tape and black vent plug (if present) from oil fill
cap.
b.
Verify that oil level is half way up the sight glass.
1.
If oil level is low, fill using SAE30 non-detergent oil or Cat Pump Oil Item
#22158.
2.
Replace oil fill cap.
Prepare
Engine
Fill the engine with oil
.
Note: The engine is shipped without oil.
Refer to the Engine Manual to locate oil-fill port and for instructions on filling.
Use the oil grade and quantity specified in the Engine Manual.
Figure 5
Oil Fill Cap
Drain Plug
Sight Glass
Summary of Contents for M157310AC.1
