Operation – Using the Pump (continued)
21
8. Rinsing
After spraying, rinse all surfaces and vegetation.
1.
Using fresh water from a garden hose, rinse any vegetation that
may have come into contact with soft wash mix.
2.
Rinse surfaces from top to bottom. Rinse until there are no visible
suds on the cleaned surface.
To extend the life of the bleach pump system's replaceable pump
cartridge:
1.
Fill tank with fresh water.
2.
Remove spray nozzle from gun and pump fresh water through the
system, discharging spray onto a hard surface such as a driveway.
3.
Do not let the pump/sprayer freeze.
NOTE:
The pump cartridge is a wear item and will fail in time. There are
two failure modes: 1.) Decreased performance or 2.) An internal leak (red
LED light on motor illuminates). See instructions in the
Maintenance
section
for replacing the pump cartridge.
9. Leaving
unattended
If the pump must be left unattended at any time
:
a)
Disconnect power to the pump.
b)
Relieve system pressure.
10. Discontinue
use if
clogged or
inoperative
If the pump becomes clogged or inoperative during use, discontinue use
immediately.
- DO NOT attempt to service while chemicals are in the pump and power is
connected.
- Return to service area to review instructions for troubleshooting before
attempting to service.
