Before Each Use
15
Follow the steps below prior to each use of the pressure washer.
STEPS TO FOLLOW BEFORE EACH USE
STEP 1. CHECK EQUIPMENT
STEP 2. ADD FUEL(S)
STEP 3. SELECT SUITABLE WORKSITE
STEP 1. CHECK EQUIPMENT
Check/add
pump oil
Check/add pump oil
.
Caution:
Never run the pump without sufficient lubrication!
1.
Check oil level. Verify that oil level is halfway up the sight glass (or at the
indicator line on the dip stick).
2.
If oil level is low, fill using Universal Tractor Transmission Oil or Mobil 1
Synthetic 15W-50 oil.
3.
Replace fill cap.
Check/add
engine oil
Check the engine oil level and add oil as needed.
Use the recommended oil type for your engine and expected ambient conditions.
(See Specification section of this manual and the engine Owner’s Manual for oil type
and capacity, and more detailed oil check/fill instructions.)
WARNING: Burn hazard
Never open oil port while engine is running. Hot oil can spray over face
and body.
Notes:
o
Low oil shutdown feature prevents the engine from starting without sufficient oil.
o
Engine is shipped without oil. You must add oil before first use.
Inspect spray
system
Always inspect spray system for damage and leaks before each use.
Do not start pressure washer until all needed repairs have been completed.
WARNING
:
High pressure fluid injection hazard
High-pressure fluid discharge from leaks (even pin-sized) or ruptured
components can pierce skin and inject fluid into the body. Injection
injury can result in blood poisoning and/or severe tissue damage leading
to infection, gangrene, and possible amputation.
•
Never use a finger or skin to check for leaks.
•
Never operate machine with damaged or missing hoses/parts.
•
Never attempt to repair a high-pressure hose or component – Always
replace it with a part that is rated at or above the pressure rating of this
machine.
