4
1-800-348-5004
DC cord has been supplied with
the unit.
GENERATOR SHUT OFF
1.Remove all electrical load
devices from the Generator. (See
Figure K.)
2.Allow the Engine to run for
approximately 3 minutes with no
electrical load.3.Turn off the
Generator’s Power Switch to stop
the Engine.(See Figure L.)
4.Turn the Fuel Switch to its
"OFF" position. (See Figure M.)
5.Allow the Generator to
completely cool before
storing.with no electrical load.
MAINTENANCE
Many maintenance
procedures, including those
not detailed in this manual, will
need to be performed by a
qualified technician for safety.
If you have any doubts allow
the Engine to stabilize.about
your ability to safely service
the equipment or Engine, have
a qualified technician service
the equipment instead
.
Air Filter Element Maintenance:
1.Wipe off the Air Cleaner Cover.
Then remove the Cover. (See
Figure N.)
2.Remove the Air Filter Element.
3.Wash the Air Filter Element in
warm water and mild detergent
several times. Rinse. Squeeze
out excess water and allow it to
dry completely. Soak the Filter in
lightweight oil briefly, then
squeeze out the excess oil.
4.Install the new Air Filter
Element or the cleaned Filter.
Secure the Air Cleaner Cover
before use.
4.Plug the power cord of the 120
volt appliance/tool into the 120
volt AC Outlet on the Generator.
(See Figure J.)
5.NOTE: Do not allow the
generator to completely run out
of fuel with devices attached. A
generator’s output may sharply
spike as it runs out of fuel,
causing damage to attached
devices.
6.When finished using the
appliance/tool, unplug its power
cord from the AC Outlet on the
Generator. (See Figure K.)
7.For DC current, plug into the
DC plug located on the side of
the generator. To charge your
car battery, connect the alligator
clips to the corresponding
terminals on your battery, The
red lead goes to the positive (+)
terminal and the black lead goes
to the negative (-) terminal. This
FIGURE J
FIGURE K
OFF
FIGURE L
FIGURE M
OFF
