Nortel Passport 8250, Command Line Interface Manual

Page: 41 / 94

Chapter 3 Provisioning ports and connections 41
Passport 8250 Command Line Interface Guide R2.2
Creating unstructured connections
Procedure
1 For E1, ensure that the value for the signal mode is none.
See “Modifying port settings” (page 31) for information on the signal
mode.
2 Ensure that you are accessing the correct board number.
See “Accessing a board in the CLI” (page 24) for information on changing
board numbers.
3 Choose the ports to map to the connections.
4 Choose the constant bit rate (CBR) clock mode.
5 Create the unstructured connections:
map <port#i>[,<#j>] <VPI#k> <VCI#l>
[cbrclock=<cbrClockMode>]
6 Verify that the connections were created and the CBR clock mode is set
correctly:
mshow [<port#>[,<#j>]] -detail
See “Searching by port number” (page 45) for information on the mshow
command.
Example
The following is an example of creating a DS-1 unstructured connection on a
single port. VPI 10 and VCI 11 are assigned to the connection. The
connection is mapped to port 1 on service board 1. The default CBR clocking
is used. The mshow command is used to verify that the connection was
created.
[Edgeplex CLI]: 1
12 to 15 100 250
16 to 23 100 225
24 to 32 100 200
Table 6 (continued)
Cdvt and MaxBuffSize parameters default values
# of time slots cdvt MaxBuffSize
(Sheet 2 of 2)