40
Chapter 2 Installing the 8010, 8006, and 8003 chassis
316314-E Rev 01
Cables
Unless you specifically ordered them, the cables required for your network
configuration are not included in the chassis accessory package. If you do not
have the proper cables, contact your network administrator.
Hardware for mounting the 8010, 8006, 8003 chassis in an
equipment rack
To install the 8010, 8006, or 8003 chassis in an equipment rack, you need a
Phillips screwdriver and an equipment rack that meets the following
specifications:
•
Heavy-duty steel construction
•
Electronic Industries Association (EIA) standard hole-spacing
•
Width of 19 in. (48.26 cm) and depth of 24 in. (60.96 cm)
Site requirements
Ensure that the installation site meets the space, electrical, and environmental
requirements listed in this section. See
Appendix A, “Technical specifications for
the Passport 8000 Series Chassis,” on page 95
for more information.
Space requirements
The installation site must provide sufficient free space around the chassis to
ensure proper ventilation and access for servicing.
Use the following guidelines to plan front and rear access:
•
The maintenance aisle in front of the frame requires a clearance of 76.2 cm
(30 inches).
•
The wiring aisle at the back of the frame requires a clearance of 61 cm
(24 inches).
Summary of Contents for Passport 8000 Series
