4-4 Installing the Aculab E1/PRI signaling option
Standard 1.0 July 1997
Installing the Aculab-based E1/PRI signaling option
software
Note:
New systems are pre-loaded at the factory with both CAS and
Enhanced DPNSS protocols. The software installation procedures
discussed in this section are required only for restoring the software or if
the signaling option is purchased separately after the initial purchase of
the base system.
There are two types of signaling option packages you can install:
•
CAS signaling option (see Procedure 4-2 on page 4-4)
•
Enhanced DPNSS ISDN PRI signaling option (see Procedure 4-3 on
page 4-7)
Procedure 4-2: Installing the CAS signaling option
1
Log in to the MRS or MRS/AP as
root
(refer to Appendix A for detailed
instructions on logging in and accessing the SCI).
2
At the
/sci>
prompt, type
install
and press
<Enter>
.
A warning message appears on the screen:
*******************************************************
WARNING - Executing this option will cause the system to
be
stopped. Once the Install Menu is entered the
only
way to restart operations will be to reboot the
VRU.
********************************************************
*****