Installing the Aculab E1/PRI signaling option 4-11
Nortel IVR 2.5/S Aculab-Based E1 CAS/ISDN PRI Signaling Guide
6
Enter the appropriate CAS number for your country or signaling option.
7
Press <Enter>.
The system displays the following:
Enter the number of DDI digits expected: 0 to 30 []:
Enter the number of CLI digits expected: 0 to 30 []:
Do you want to strip calling line category digit?
[y/n]:
8
Enter the appropriate information and press <Enter>.
The system prompts you to verify the current configuration:
This system will be configured using
x country
parameters
ACL Type =
xx port
ACL Firmware =
xxxxx
Number of DNIS (DDI) digits =
x
Number of ANI (CLI) digits =
x
Do you wish to continue the installation [y/n]:
ATTENTION
If you installed the CAS signaling option for Belgium, Brazil, China,
Mexico or Malaysia, the system prompts you to enter the number of
Direct Dialed Inward (DDI) and Calling Line Identity (CLI) digits to be
used. (DDI and CLI are equivalent to DNIS and ANI, respectively.)
Consequently, it is suggested that you know the number you will need
before installing the country parameters. (If you do not know the
appropriate number, specify a sufficiently high number of digits.)