Nortel FastRad, Installation Manual

Page: 24 / 35

14
FastRAD Installation Guide
Programming
Alarm
Reporting
The alarm programming session allows you to program the
FastRAD to report alarms to the telephone number of a
dedicated alarm center, such as a printer or terminal.
Before you begin an alarm programming session, make sure
the display shows
RAD Admin
.
If you do not have this display on the Norstar telephone, follow
the steps listed in Starting a Programming Session.
To program the FastRAD Alarm Reports:
1. Press
ALARM
.
The display shows:
2. Press
CHNG
to turn automatic alarm reporting on.
The display shows:
3. Press
NEXT
.
The display shows:
4. Press
CHNG
.
The display shows:
5. Enter the KSU line number the FastRAD uses for remote
connections. Refer to the Programming Record for the
correct line number.
6. Press
NEXT
.
The display shows:
7. Press
SHOW
to see where the FASTRAD reports its alarms.
The display shows:
Auto-report: OFF
BACK CHNG NEXT
Auto-report: ON
BACK CHNG NEXT
Report line: 001
BACK CHNG NEXT
Report line:_
CLEAR BKSP OK
Alarm number 1
BACK SHOW NEXT
<Alarm number>
BACK CHNG NEXT
855601 Book : 855601 Guide Page 14 Wednesday, October 29, 1997 4:06 PM