Nortel FastRad, Installation Manual

Page: 21 / 35

11
FastRAD Installation Guide
Starting a
programming
session
The FastRAD cannot be used for remote or direct connections
until the user password has been programed through Feature
9**. This initial password programming must occur on-site.
IMPORTANT : There is no way to recover a lost or forgotten
password or return to the default state.
A FastRAD is programmed from a Norstar two-line display tele-
phone that is connected to the KSU. Programming information
is entered into the FastRAD using the dialpad on the telephone.
Follow the prompts that appear on the display.
Note : You cannot start a programming session while you are
on a call. When a programming session is in progress, press
only the buttons indicated. The programming session is termi-
nated when you press incorrect buttons or when you make or
answer a call. Only on a DR2 KSU can you put the programming
session on hold to make or answer a call.
If you need to go back a step while you are programming, press
BACK
or press
®
and start again. If you stop programming
for more than three minutes, the display returns to the date and
time, and you must restart programming from the beginning.
IMPORTANT : You must wait 60 seconds before you attempt to
program the FastRAD when: the FastRAD is connected or
restarted; the power supply is disconnected or the KSU is
restarted.
To start a programming session:
1. Press
ƒ·••
.
The display shows:
Note : When the password has been changed, the display
shows:
Enter password
. Check the FastRAD installation
wiring and start again if the display shows:
Inactive
feature
. For more information, refer to Troubleshooting ,
later in this guide.
Password
EXIT CHNG NEXT
855601 Book : 855601 Guide Page 11 Wednesday, October 29, 1997 4:06 PM