AT commands 41
P0873832 Issue 05
CTA 500
dm On Line Guide
Call Monitoring Result Code Selection
The Call Monitoring Result Code Selection Command
X[value]
controls the format of result codes sent by the CTA 500
dm
in
verbose mode during call setup. (See possible values in the
following table.) Values 1 and 2 are identical since the CTA 500
dm
does not support dial tone detection.
Result Codes
OK
Appears when the value is acceptable.
ERROR
Appears when the value is unacceptable.
S-registers
The S-registers allow you to control CTA 500
dm
operation. The
registers are usually both read and write accessible. The registers
used vary with the application supported by the CTA 500
dm
. All
S-registers are saved as part of a CTA 500
dm
proÞle. S-registers can
appear as a group by using the &V command (see
ÒGeneralÓ on
page 35
for more information).
S-register commands summary
Value
Result Code Operation
0
connect result code, no busy detection
1
connect rate result code, no busy detection
2
connect rate result code, no busy detection
3
connect rate result code, busy detection
4
connect rate result code, busy detection (default)
Command
Description
Value
Sn=
set value to S-register
depends on register
Sn?
query S-register value
