Nortel Alteon OS, Command Reference Manual

Page: 20 / 382

Alteon OS Command Reference
20
„
Chapter 1: The Command Line Interface 40M2420, April 2007
Connecting to the Switch
You can access the command line interface in any one of the following ways:
„
Using a Telnet via the management module
„
Using a Telnet connection over the network
„
Using a SSH connection to securely log into another computer over a network
„
Using a serial connection using the serial port on the GbESM
Management Module Setup
The BladeCenter GbE Switch Module is an integral subsystem within the overall BladeCenter
system. The BladeCenter chassis includes a management module (MM) as the central element
for overall chassis management and control.
You can use the 100 Mbps Ethernet port on the management module to configure and manage
the GbE Switch Module. The GbE Switch Module communicates with the management mod-
ule through its internal port 15 (MGT1) and port 16 (MGT2), which you can access through the
Ethernet port on the management module. The factory default settings will
permit only man-
agement and control access to the switch module through the Ethernet port on the management
module, or the built-in serial port. You can use the six external 10/100/1000 Mbps Ethernet
ports on the switch module for management and control of the switch by selecting this mode as
an option through the management module configuration utility program (see the applicable
BladeCenter Installation and User’s Guide publications for more information).
Factory-Default vs. MM assigned IP Addresses
Each GbE Switch Module must be assigned its own Internet Protocol address, which is used
for communication with an SNMP network manager or other transmission control protocol/
Internet Protocol (TCP/IP) applications (for example, BootP or TFTP). The factory-default IP
address is 10.90.90.9x, where x corresponds to the number of the bay into which the GbE