184
Switch administration tasks
Parameters and
values
Description
•
broadcast: Apply rate-limiting to broadcast
packets.
•
both: Apply rate-limiting to both multicast and
broadcast packets.
no rate-limit command
The
no rate-limit
command disables rate-limiting on the port.
The syntax for the
no rate-limit
command is:
no rate-limit [port <portlist>]
Run the
no rate-limit
command in Interface Configuration command
mode.
"No rate-limit parameters" (page 184)
describes the parameters for this
command.
No rate-limit parameters
Parameters
Description
port <portlist>
Specify the port numbers to disable for rate-limiting.
Enter the port numbers to disable.
Note: If you omit this parameter, the system uses the
port number you specified in the
interface
command.
default rate-limit command
The
default rate-limit
command restores the rate-limiting value for
the specified port to the default setting.
The syntax for the
default rate-limit
command is
default rate-limit [port <portlist>]
Run the
default rate-limit
command in Interface Configuration
command mode.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
