Nortel 425-24T, Configuration Manual, Page: 257 / 488

Chapter 7 System configuration using the CLI 257
System Configuration Guide
Figure 93 displays a sample output of the
show ip address
command.
Figure 93 show ip address command output
Assigning and clearing IP addresses for specific units
You can assign IP addresses for specific units within a stack. This section covers
these topics:
• “ip address unit command”
• “no ip address unit command” on page 258
• “default ip address unit command” on page 258
ip address unit command
The
ip address unit
command sets the IP address and subnet mask for a
specific unit in the stack. The syntax for the
ip address unit
command is:
ip address unit <1-8> A.B.C.D
The
ip address unit
command is in the config command mode.
Table 63 describes the parameters and variables for the
ip address unit
command.
Table 63 ip address unit command parameters and variables
Parameters and
variables
Description
unit <1-8> Sets the unit you are assigning an IP address.
A.B.C.D Enter IP address in dotted decimal notation.
425-24T(config)#show ip address unit 1
Configured In Use Last BootP
--------------- --------------- ---------------
Stack IP Address: 0.0.0.0 0.0.0.0
Default Gateway: 192.168.151.1 192.168.151.1 0.0.0.0