Nortel 4050, Installation Manual

Page: 27 / 46

Chapter 2 Installation Process 27
Nortel Secure Network Access Switch 4050 Installation Guide
Installing the switch in a rack
Install the Nortel Secure Network Access Switch 4050 in a rack using the four
supplied rack mount screws. For rack installation, mounting brackets are shipped
attached to the front of the unit.
Follow these steps to install the unit in a rack:
1 Identify a rack location and hole spacing alignment.
2
Separately supporting the full weight of the unit, use a #2 Phillips screwdriver
to seat the four mounting screws through the front brackets and into the rack
frame.
Continue the installation process by connecting the power supply. (See
“Supplying power to the switch” on page 28 .)
Installing the switch on a shelf or tabletop
Install the Nortel Secure Network Access Switch 4050 on a flat surface using the
supplied bezel adapter kit with 4 rubber feet.
Follow these steps to install the unit on a flat surface:
1 Identify a stable shelf or tabletop location.
2
Using a #2 Phillips screwdriver, remove and replace the 2 rack mount brackets
with the 2 bezel adapter kit brackets.
3
Remove the protective film from each of the supplied rubber feet and affix the
feet to the four bottom corners of the unit.
Continue by connecting the power supply. (See “Supplying power to the switch”
on page 28 .)