Nortel 1000E PRI, Installation And Commissioning Manual

Page: 104 / 162

104 Configure an E1/T1 card
Prompt Response Description
DES DPNSS Designator field for trunk.
... ...
DDSL 0 - 15 DASS2/DPNSS D-channel logical port number, entered in
LD 74.
SIGL DPN/DAS DPN = DPNSS signaling
DAS = DASS signaling
CUST xx Customer number, as defined in LD 15.
NCOS (0) - 99 Network Class of Service group.
... ...
RTMB 0-511 1-4000 Route number and member number.
Range is the same as that for CS 1000E system.
... ...
TGAR 0 - (1) - 31 Trunk Group Access Restriction. The default "1"
automatically blocks direct access.
... ...
CLS aaaa Class of Service.
... ...
--End--
Enable PRI spans
For every span on the E1/T1 card, enable the NTBK51AA/NTBK51CA card
or the NTAK93AB daughterboard and enable the clock controller.
If you use the NTBK51AA/NTBK51CA daughterboard, follow the procedure
described in
Procedure 33 “Enabling the NTBK51AA/NTBK51CA
daughterboard” (page 104) to enable the PRI spans through software.
If you use the NTAK93AB daughterboard, follow the procedure described
in
Procedure 34 “Enabling the NTAK93AB daughterboard” (page 105) to
enable the DPNSS/DASS spans through software.
To enable the clock controller, follow the procedure described in Procedure
35 “Enabling the clock controller” (page 105) .
Procedure 33
Enabling the NTBK51AA/NTBK51CA daughterboard
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.