Flex Match
11
(2). Hang the remaining 2 latches to the hooks on the sides of the indoor unit. (Be careful not to
let the swing motor lead wire get caught in the sealing material.)
(3). Screw the 4 hexagon head screws under the latches in about 15mm (1/2 in). (The panel
will rise)
(4). Adjust the panel by turning it toward the direction pointed by the arrow as shown in Fig. 13,
so that the adjust board connect the ceiling well.
(5).
Tighten the screws until the thickness of the sealing material between panel and indoor unit
reduced to 5-8mm (1/4-1/8 in).
Latch
Piping position
Swing flap moto
r
Indoor unit
Ceilin
g
Air outlet vent
Decoration panel
5mm to 8mm
Sealing material
Hook
Fig. 13
