NORMARC NM 7000 Series, Installation & Commissioning Handbook

Page: 154 / 189

1250$5&
,167580(17/$1',1*6<67(0
,167$//$7,21 &200,66,21,1*+$1'%22.
‹1DYLD$YLDWLRQ$6
2.2 Adjustment points
The adjustment points are shown in Figure 2-3 Adjustment points and explained below. The
figure shows a fully equipped system, NM 7050D, see Section 3 for configuration details:
1. Battery charging voltage (nom 27.4V@20
°
C)
2. Bias for power transistor (use factory settings)
3. Battery protection cut-off voltage (nom. 22V)
4. Tx Detected Rf level (nom. 2.5V@4W carrier)
5. Monitor RF level (nom. 3V@nominal output power)
6. Monitor frontend input filter centre frequency (use factory settings)
7. Real time clock fine tuning(use factory settings)
⇒
The adjustment points marked
Use Factory Settings
should not be touched.
⇒
The baseband level has to be adjusted at installation.
⇒
The other are factory pre-set but may be adjusted.