54
55
Installing the Remote Controller
For outdoor wiring
...... Note) An outdoor cover set for bathroom (separately sold) is required.
[Phillips roundhead wood screws and wall plugs are not
necessary for outdoor wiring.]
Remote controller
cord
1. Insert the connecting electric cord into the stay
pipe, and secure the stay pipe firmly into the
remote controller. Then put the wall packing
into the stay pipe and attach it on the rear side
of the remote controller.
2. Drill a
φ
32 mm hole on the wall.
3. Insert the stay pipe containing the connecting
electric cord into the hole on the wall.
4. Fit the slip preventive packing and outdoor
cover onto the connecting electric cord
protruding from the outside wall.
5. Put through the cap nut on the connecting cord,
and screw the cap nut onto the stay pipe.
6. Connect the connector in the outdoor cover.
Wind the redundant length of the connecting
cord on the hook shown in the illustration below.
7. Close the outdoor cover.
Tie the redundant length of the remote
controller cord outside the outdoor cover.
Rear side of remote controller
Wall packing
Secure the stay pipe
firmly into the remote
controller.
Take off the
released paper.
φ
32 hole
About 300 mm
Wall packing
Stay pipe
Take out the pipe about
20 mm from the wall.
Outdoor cover
Connecting
electric cord
Slip preventive packing
Stay pipe
Cap nut
Connecting
electric cord
(Wind the
redundant cord
here.)
Connecting
electric cord
Outdoor cover
Cap nut
Take off the
released paper.
For in-wall wiring
1. Put the remote controller cord through the wall
from the bathroom. Be sure to place the 2P
connector at the room side.
Ordinary bathroom
and shower room
Unit bath and
shower unit
A back support board illustrated below is
needed to install the remote controller on the
wall panel of the unit bath.
[Install the back support board at the rear side
of the wall panel prior to installation.]
φ
6 hole
(25 to 30 mm deep)
2. Drill two holes (6, 25 to 30 mm deep) on the
wall to secure the remote controller case, and
embed the wall plugs into the holes.
3. Take off the decorative frame from the remote
controller.
4. Apply the wall packing to the rear side of the
remote controller.
5. Connect the connector.
6. Secure the remote controller with two Phillips
roundhead wood screws.
7. Fit the decorative frame on the remote controller.
118 mm
Phillips roundhead wood screw
Wall plug
Remote controller cord
Wall packing
(take off the released paper)
Connecting
electric cord
Rear side of
remote controller
Use the JIS-C83361 switch box for individual
use at the remote controller side.
Dimensions of back support board (reference)
2P connector
Switch box
Bath tub
Bath tub
Conduit
(Nominal: diameter
φ
19)
Switch box
Switch box
118 mm (machine screw pitch)
φ
3 hole
φ
32 hole
Waterproofed
plywood board
Seal this part sufficiently.
Through-hole ø 32 to ø 35
Summary of Contents for N-084
Page 30: ...58...
