ENGLISH
15
ENGLISH
14
C
7
Remove and clean one cutter and comb at a
time.
Do not clean more than one cutter and comb at
a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
8
Separate the cutter from the comb.
C
9
Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
C
10
Brush the slots of the comb.
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Norelco Razor Head Cleaner, model RC1776
or alcohol) and lubricated with Norelco Razor
Lubricant, model AL80, or one drop of mineral oil
(in the center of the head). This helps prevent
wear of the shaving heads.
C
11
Replace the cutter and comb into the Razor
Head Assembly.
12
Repeat the process for the other two sets of
cutters and combs.
13
Replace the frame.
C
14
Turn the wheel clockwise until it locks into
place.
C
3
Brush out hairs from the inside of Razor
Head Assembly and hair chamber.
C
4
Replace the Razor Head Assembly back on
razor.
Every Two Months: Razor Heads
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1
Turn razor to Off (O) position, remove plug
from outlet and disconnect cord razor.
C
2
Press the Razor Head Release Button and
remove Razor Head Assembly from the
razor unit.
C
3
Brush the inside of the razor housing.
4
Turn Razor Head Assembly over so that
underside is exposed.
C
5
Turn wheel of frame counterclockwise.
6
Remove the frame and brush clean.
6844XL 5/7/03 1:43 PM Page 14
