3.3
Set controller to Single-door mode
Factory default setting is single door mode, if user does not sure about the mode, please
set it again, the steps please follow:
03, 1#
3.4
Set door opening time to 2s
Assuming it is an electric mortise lock, the factory default opening time is 2S, no
adjustment is required. Just adjust the unlocking time of the special power supply for access
control to the minimum. If you are not sure what the door opening time of the machine is, you
need to reset it. The steps are: 34, 2 #
3.5
Add User Card
or Fingerprint
10, read card (or press fingerprint twice), read card (or press fingerprint twice) …repeat the
operation till the last user card.
Note: the controller can read multi-cards or fingerprints continuously, each fingerprint press
twice. When you hear a long “beep- “and indicator light turn to green it means the new card or
fingerprint added successfully. After finishing the last card or fingerprint, please press the * key
to exit.
3.6
Exit Management menu operation mode
In Management menu operation mode, press * more than once until the indicator light turn
to red and always bright means exit Management menu operation mode.
3.7
User open door
When the indicator light is red and always bright, read card, or press user fingerprint or
press exit button.
Note: When the door opens, there is a long "beep" sound and the indicator light turns to
green when the door is unlocked.
Fingerprint Standalone
Access Control User Manual
