Nordson Encore LT Automatic, Customer Product Manual

Page: 37 / 71

Operation
4-3
Part 1604858-01
E
2013 Nordson Corporation
Recoat
Metallics Deep Recesses
Figure 4-2 Select Charge Mode
NOTE: If you press the STD/AFC selection button while using a Select
Charge mode, the controller switches to Classic or Custom mode.
Custom Electrostatic Mode
Custom Mode
is the factory default electrostatic mode.
In Custom mode, both kV output and microampere (μ A) output limits can be
adjusted independently. Both the kV and AFC LEDs light to indicate that the
controller is in this mode.
Use the View button to toggle the display between kV and μ A. Press
the + or − buttons to enter the desired setpoints. The longer the button is
pressed the faster the units change.
S
The valid AFC range is 5 − 100 μ A.
S
The valid STD range is 0 or 25 − 100 kV.
Classic Electrostatic Mode
Classic Mode is the optional electrostatic mode. The controller must be
configured to use this mode. Refer to page 3-11 for instructions on changing
the electrostatic mode.
In Classic mode you can choose to control kV output (STD) or μ A output
(AFC), but not both at the same time.
Classic Standard (STD) Mode
See Figure 4-3. Use the STD mode to set the no-load output voltage (kV).
1. Press the STD/AFC button to toggle between STD and AFC.
The LEDs light to show which is selected. Select STD. The STD LED
lights.
2. Press the View button to toggle the display between kV and
μ
A.
Press the + or − buttons to enter the desired kV setpoint. The longer a
button is pressed the faster the units change.
The valid STD range is 0 or 25 − 100 kV.