Nordson Encore LT Automatic, Customer Product Manual

Page: 31 / 71

System Setup
3-11
Part 1604858-01
E
2013 Nordson Corporation
Entering Configuration Mode
To enter configuration mode, press and hold the Plus and Minus buttons
simultaneously on the kV/uA panel, then either turn on power, or if the
controller is disabled press the Enable/Disable button. After 1 second all
panels will flash CF for 3 seconds. After 3 seconds the kV/
μ
A panel displays
F − 1 for function 1. The controller is now in configuration mode.
To save your settings and exit configuration Mode, press the
Enable/Disable button.
Atomizing Air
(Classic)
Total Flow
(Smart Flow)
Smart Coat Settings
KV/ μ A Panel
KV/uA Selection
Smart Flow
Mode Indicator
Flow Air
(Classic)
Powder Flow Rate
(Smart Flow)
Enable/Disable
Trigger LED
Figure 3-10 Controller Interface
Function Settings
To change functions press the + or − buttons on the kV/
μ
A panel.
To change function settings press the + or − buttons on the Flow Air panel.
Function No. Name Settings Default
1 Gun Type 0 = Encore 0
2 Trigger Type 0 = External, 1 = Continuous 0
3 Electrostatic Control 0 = Custom, 1 = Classic, 2 = PE 0
4 Powder Flow Control 0 = Smart, 1 = Classic 0
5 Cable Length 0 = 8 meters, 1 = 12 meters, 2 = 16 meters 0
NOTE: Refer to the Operation section for explanations of the Electrostatic
Control and Powder Flow Control modes.