Nordson Encore HD iControl System, Hardware Manual

Page: 46 / 93

Troubleshooting
4-6
Part 1603054-02
E 2015 Nordson Corporation
Refer to
Page
Description Message Text Code
410x Color Change
4109 Clean cycle aborted arch
clean operation − waiting on
park release
Clean cycle detected an abort − waiting for
user to press park to release.
4-18
4110 Clean cycle aborted by user
action − park release
detected
Clean cycle aborted by user − part release
was detected.
4-18
4111 Clean cycle aborted detected
machine lockout/watchdog
A machine malfunction aborted the cleaning
operation.
4-18
CAN Network Errors
Table 4-2 CAN Network Errors
Error
Code
Message Cause/Correction
101 CAN bus fault detected Hardware error. Check the CAN cable for shorts. If the
cable is good, replace the PC104 CAN card.
102 CAN receive buffer overflow Host CAN interface received too much data and could
not process it quickly enough. Reboot the system.
103 Message timeout Remote CAN device did not respond to a direct request
in the allotted time. Check the gun card or iFlow card.
104 Went offline Normal operational message. The user will see this
message if the booth exhaust fan is shut off, which
removes power from gun cards, or if the gun card is
disconnected, or if the iFlow module is disconnected
from the CAN network.
105 Returned to online Normal operational message. No action required.
107 Communications errors These error messages indicate that communications on
the iControl CAN bus may be having problems.
Troubleshooting should include verification of all CAN
cable connections and grounding, and gun cable
connections and continuity. CAN errors can also be
caused by individual gun cards or the iControl PC to
PC104 card interface. These errors do not indicate a
specific device failure as all devices are in parallel on the
CAN bus.
108
109
110
111
112
113
Obsolete