Encore Manual Spray Gun - Trigger Switch Replacement
5
Part 1096694A
E
2009 Nordson Corporation
28
28
Clear tubing
23
Tube Guides
22
20
Figure 9
Handle Assembly
4. See Figure 10. Hook the ground pad (27) behind the locator tabs and
rotate the ground pad into position against the handles.
5. Attach the base (22) to the handles with the two M3 x 20 screws (12).
Hand tighten the screws only.
22
12
27
Locator Tabs
27
Figure 10
Installing Ground Pad and Base
6. Make sure the power supply is correctly installed in the gun body, with
the gun body rib between the mating grooves on the power supply.
Press on the end of the power supply to ensure that the contact in the
end is seated against the contact tip in the gun body.
Align Ribs and Grooves
Figure 11
Power Supply Installation
7. See Figure 5. Make sure the O-ring is installed on the inlet tube (23).
Install the elbow (13) onto the end of the inlet tube.
8. See Figure 12. Position the lower edge of the bulkhead cover (8)
behind the handle screw boss, then rotate the top of the cover forward
until it snaps into place on the handle.
