Waste Big Bag
11
Part
7093466
E
2021
Nordson Corporation
Maintenance
WARNING:
Breathing in certain airborne dusts (including finishing
powders) may be hazardous to health. Ask the powder manufacturer for a
Material Safety Data Sheet (MSDS) for information. Use appropriate
respiratory protection.
CAUTION:
It is important to follow the specific maintenance instructions of
each product.
NOTE
: R
= Responsible person for performing the task.
Int
= Intervals at which this should be carried out
Maintenance
Location
Task
Procedure
R
Int
Waste Big Bag
Inspect level of
waste powder
If bag is filled to up to the maximum. Follow local
disposal regulations
OP
8
Waste Big Bag
Check
grounding
clamp on bag
Grounding clamp must be connected to big bag
grounding point
OP
8
Powder hose
Check powder
hose
No powder restrictions or tight bends
OP
8
Vent Hose
Inspect and
clean vent hose
(if applicable)
Ensure it’s not clogged or any restrictions in air path
OP
8
Prodigy HDLV
Transfer Pump
Check if
transfer pump
is functioning
Check supply air is 5 bar and also that there is not a
restriction/blockage in the powder delivery hose
OP
24
Prodigy HDLV
Transfer Pump
Inspect clear
block for signs
of powder leak-
age
Ensure no powder is around the pinch valves. If
powder is present inside the clear block, replace the
pinch valves according to the relevant technical
manual.
OP
600
Filter
Replace the
Filter cartridge
(if applicable)
Replace the Filter cartridge
TT
1000
Prodigy HDLV
Transfer Pump
Replacement of
wear parts
Replace fluid
−
tubes and pinch valves at the same time
TT
2000
Level Sensor
(if fitted)
Functional
check of level
sensors
Check if level sensors are detecting correctly. Adjust
the settings if needed
TT
4000
