If water is left inside the machine at the end of the programme
•
The water drain hose is clogged or twisted.
•
The filters are clogged.
•
The programme is not finished yet.
If the machine stops during a wash operation
•
Power failure.
•
Water inlet failure.
•
Program can be on standby mode.
If shaking and hitting noises are heard during a wash operation
•
Dishes placed incorrectly.
•
Spray arm hitting the dishes.
If there are partial food wastes left on the dishes
•
Dishes placed incorrectly into the machine, sprayed water did not reach related places.
•
Basket overly loaded.
•
Dishes leaning against one another.
•
Very small amount of detergent added.
•
An unsuitable, rather weak wash programme selected.
•
Spray arm clogged with food wastes.
•
Filters clogged.
•
Filters incorrectly fitted.
•
Water drain pump clogged.
If there are whitish stains on the dishes
•
A very small amount of detergent is being used.
•
Rinse aid dosage setting at a very low level.
•
No special salt is being used despite the high degree of water hardness.
•
Water softener system setting is at a very low level.
•
Salt compartment cap not closed well.
If the dishes won't dry up
•
A programme without a dry operation selected.
•
Rinse aid dosage set too low
•
Dishes unloaded too fast.
If there are rust stains on the dishes
•
Stainless-steel quality of the dishes washed is insufficient.
•
High rate of salt in the wash water.
•
Salt compartment cap not closed well.
•
Too much salt spilt into the sides and into the machine while filling it with salt.
•
Unhealthy mains grounding.
Call an authorised service if the problem still persists after the controls or in case of any
malfunction not described above.
2
6
