English
Owner
’
s Manual
ODR-C
4/8
Level
This knob
H
adjusts the output-volume of the ODR-C.
Drive
This control
I
set the amount of overdrive. It can be adjusted between "almost clean" and "heavily
overdriven". The volume changes depending on the position of the knob. Then, if necessary, adjust the
volume with the Level-control
H
. The overdrive circuit limits the signal and therefore it sounds more
compressed (longer sustain) and it produces a lot of harmonics too.
Spectrum
This control
J
has always been special! Unlike other devices on the market (called Tone or Treble), which
prune the signal simply in the treble (dull control) I use an active electronics, which regulates not only the
treble (from about 1 kHz), but likewise the basses around approx. 300 Hz - so rather the lower middle range.
Orange:
The center-position is the normal sound. In this position the button engages noticeably.
Gray:
Turning the knob to the right raises treble and bass.
Green:
Turning the knob to the left will lower treble and bass accordingly.
What remains is a good sounding middle section (600 Hz to 1 kHz). This results in well playable
sounds in all positions.
