Nordisk Teltbutikk SST304716, Assembly Instructions Manual

Page: 15 / 19

Page 15
C-INSTALLING COVER
NOTE: DO NOT install the cover onto the frame of your building in high wind conditions. A slight
breeze is the most advantageous for cover installation. To take advantage of the breeze, pull the
cover up over the arches with the breeze blowing in the cover like a sail filled with air.
1. Roll out the roof cover on a ground sheet. Align the cover evenly to each end of the frame. Be
sure doing not over pull the end of roof cover.
2. Pull the cover over frame EVENLY, CAREFULLY AND SLOWLY. Insert tensioning tubes
(No.8) into the cover pipe pockets. Cut a small opening on the pipe pocket over against every
base plate. Put the Belt (No.17) around tensioning tube and then go through winch (No.14) and
loosely secure. DO NOT TIGHTEN. Adjust the cover so that it is square and evenly centered on
the frame.
Note: The end flaps must overhang evenly at both ends.
3. Use Cable Tie (No.16) to fix roof cover to end arches first. Then use the supplied Knitting Rope
(No.15) to tighten the roof cover to the end arches. The rope should be cut as your requirements
when using. The recommended procedure is to use separate pieces of rope and start by first
lacing the cover from the bottom edges up to the top center. Secure the ropes at the top center
and then apply tension as you lace down both sides. Fasten the rope at the bottom edge.
4. When roof cover is tidy and ready, drive the winch tie down forth and back and then roof cover
is tightened.
5. Tidy the cover. Pull the band inside the end of roof cover, make the cover well fold to end
arches and fasten the band.
6. Install Front and Back Cover (No.34&23) to front and back end wall by cable tie (No.42&28).
Note: if there is damage for cover when use, please repair it as soon as possible
to avoid further damage.