27
Most incline trainer problems can be solved by fol-
lowing the simple steps below. Find the symptom
that applies, and follow the steps listed. If further
assistance is needed, see the front cover of this
manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
properly earthed outlet (see page 14). If an exten-
sion cord is needed, use only a 3-conductor,
14-gauge (1 mm
2
) cord that is no longer than 5 ft.
(1.5 m).
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in.
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the incline trainer still will not run, please see the
front cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a. The console features a display demo mode,
designed to be used if the incline trainer is dis-
played in a store. If the screen remains lit when you
remove the key, the demo mode is turned on. To
turn off the demo mode, see step 6 on page 23.
SYMPTOM: The incline of the incline trainer does
not change correctly
a. Recalibrate the incline system. See step 4 on
page 24.
SYMPTOM: The console does not display speed
and distance correctly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the three indi-
cated #8 x 1/2" Cover Screws (18). Lift off the Left
Roller Cover (38).
TROUBLESHOOTING
Reset
Tripped
c
18
18
a
38
