12
10. Firmly tighten the two 5/16" x 1" Bolts (7) and the
four 5/16" x 1" Flat Head Screws (10) (only one
side is shown).
With the help of a second person, hold the con-
sole assembly near the Left Handrail (71) and
the Right Handrail (not shown).
Connect the ground wire from the console
assembly to the Console Ground Wire (89).
Next, connect the Upright Wire (70) to the
console wire. See the inset drawing. The
connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again. IF YOU DO NOT
CONNECT THE CONNECTORS PROPERLY,
THE CONSOLE MAY BECOME DAMAGED
WHEN YOU TURN ON THE POWER. Then,
remove the wire tie from the Upright Wire.
10
Console
Assembly
89
70
10
70
Ground Wire
Wire
Tie
Console
Wire
Console
Wire
71
7
11. Set the console assembly on the Left and Right
Handrails (71, 72). Make sure that no wires
are pinched. Insert the excess Upright Wire (not
shown) into the Left Handrail and the ground
wires (not shown) into the console
assembly.
Attach the console assembly to the Pulse
Crossbar (31) with six #8 x 3/4" Screws (6).
Start all six Screws, and then tighten them.
Attach the two Console Clamps (96) to the con-
sole assembly with four #8 x 1" Screws (94).
11
31
96
71
Console
Assembly
6
6
94
6
6
72
