NordicTrack SpaceSaver SE5i, User Manual

Page: 19 / 28

19
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. To adjust the drive belt,
first unplug the power adapter.
Next, remove the indicated M4 x 16mm Screw (61),
the Left Leg Inner Cover (39), and the Left Leg Outer
Cover (92).
Then, remove the two M8 x 16mm Screws (76) and the
two M8 Washers (33) from the Left Upper Body Leg
(101) and the Left Pedal Arm (14).
Next, remove
the M8 x 14mm
Shoulder Screw
(81) from the Left
Pedal Arm (14),
and then remove
the Left Pedal
Arm.
See the lower drawing at the left. Remove the
four M4 x 16mm Screws (not shown) from the Large
Storage Foot (27), and then remove the Large
Storage Foot. Remove the two M4 x 16mm Screws
(not shown) from the Top Shield (37), and then use a
standard screwdriver to pry the Top Shield upward off
the elliptical. Then, pry the left Pedal Disc (26) off the
elliptical.
See EXPLODED DRAWING C on page 27. Identify
the Left and Right Shields (44, 45). Remove all of the
M4 x 16mm Screws (61) and 3/16" x 1 3/8" Screws
(64) from the Left and Right Shields. Make sure to
note which size Screws come from which holes.
Then, carefully remove the Left Shield.
Loosen the Idler Screw (97). Tighten the Idler
Adjustment Screw (72) until the Drive Belt (46) is tight.
When the Drive Belt is tight, retighten the Idler Screw.
When you are finished, reattach the parts that you
removed. Then, plug in the power adapter.
39
33
33
92
101
76
14
76
61
37
14
81
26
27
46
72
97