5
4
46
73
Console
Cable
Console
Cable
Console
Wire
3
3. With the help of another person, thread the console
cable through the large round hole in the Handlebar
(3) and down through the Upright (2). Thread the
console wire through the same hole in the
Handlebar and connect it to the Extension Wire (73).
Hold the Console (4) and the Handlebar (3) near
the Upright (2). Push any excess wire or cable into
the Upright. Attach the Console and the Handlebar
to the Upright with four M9.5 x 25mm Button
Screws (51) and four M10 Lock Washers (11).
Press the Resistance Knob (46) onto the Console
(4) as shown.
3
11
11
11
11
11
11
11
11
12
12
51
51
51
2
4. Hold the Upright (2) in the position shown.
Refer to the inset drawing. Make sure that the indi-
cated nut is threaded fully onto the connector on the
Resistance Cable (40). Insert the tip of the console
cable into the indicated opening, pull up on the con-
sole cable, and insert the console cable into the
open end of the connector. Turn the nut counter-
clockwise one or two turns until the console cable is
held snugly in the connector. Note: If there is a clear
plastic sleeve on the Resistance Cable, position the
sleeve so that it covers the connector.
Connect the Reed Switch Wire (66) to the Extension
Wire (73).
Making sure not to pinch the wires or cables,
slide the Upright (2) onto the Frame (1). Attach the
Upright with four M10 x 25mm Button Screws (12)
and four M10 Lock Washers (11).
4
2
1
40
66
73
Console
Cable
Connector
40
Slot
Nut
