10
81
90
7
G
7. With the help of a second person, set the
console base assembly (G) on the Right Upright
(90) and the Left Upright (not shown). See the
inset drawing. Position the Upright Wire (81) so
that it is on the inside of the Upright as shown.
Do not pinch the Upright Wire.
Partially tighten a 5/16" x 3/4" Screw (8) into the
center hole (H) on each side of the console
base assembly (G) and the top of the Right
Upright (90) and the Left Upright (not shown);
do not fully tighten the Screws. Note: The
Screws are used only to hold the console
base assembly in place during assembly.
8
81
H
90
8. Identify the right handrail assembly (I). Remove
and discard the two indicated screws (J).
Next, carefully raise the Pulse Crossbar (93)
enough to allow you to slide the Handrail (86)
onto the console base assembly (G). See the
inset drawing. The Cover Bracket (18) should
slide into the indicated space (K) in the hand-
rail assembly.
Attach the right handrail assembly (I) with two
5/16" x 2 1/2" Screws (28) and two 5/16" Star
Washers (11); do not fully tighten the Screws
yet. Tip: You may need to adjust the position
of the right handrail assembly to align the
Screws properly.
Attach the left handrail assembly (not shown)
to the left side as described above.
28
11
J
86
8
I
K
18
K
G
93
H
