10
7
3.
Slide a Brace (2) onto the bracket on one of the
Uprights (1). Attach the Brace to the Upright with two
M10 x 65mm Bolts (26), four M10 Washers (3), and
two M10 Nylon Locknuts (7). Do not tighten the
Nylon Locknuts yet.
Slide the Upright (1) and the Brace (2) onto the M10
x 65mm Carriage Bolts (24) and the M8 x 65mm
Carriage Bolts (38) in the left Base (4). Attach the
Upright with two M10 Nylon Locknuts (7). Attach the
Brace with two M8 Washers (35) and two M8 Nylon
Locknuts (37). Do not tighten the Nylon Locknuts
yet.
3
1
7
3
3
Bracket
24
38
7
26
2
4
35
37
4.
Slide the other Brace (2) onto the bracket on the
other Upright (1). Attach the Brace to the Upright with
two M10 x 65mm Bolts (26), four M10 Washers (3),
and two M10 Nylon Locknuts (7). Do not tighten the
Nylon Locknuts yet.
Slide the Upright (1) and the Brace (2) onto the M10
x 65mm Carriage Bolts (24) and the M8 x 65mm
Carriage Bolts (38) in the right Base (4). Attach the
Upright with two M10 Nylon Locknuts (7). Attach the
Brace with two M8 Washers (35) and two M8 Nylon
Locknuts (37). Do not tighten the Nylon Locknuts
yet.
4
1
26
7
3
4
38
2
24
3
7
37
35
Bracket
12. Attach the upper end of one of the Weight Guides
(11) to the bracket on the Upright (1) with an M8 x
30mm Bolt (22) and an M8 Washer (35).
Attach the other Weight Guide (not shown) to the
other Upright (not shown) in the same manner.
Tighten all of the nylon locknuts used in steps 1
to 10.
13. Make sure that all parts are properly tightened
before you use the weight rack. The use of all
remaining parts will be explained in Adjusting the
Weight Rack starting on the following page.
22
11
35
1
12
11. Note: If you are not planning to use Olympic
weights with the weight rack, centre the Barbell
(21), and tighten the M8 x 20mm Screws (33) used
in step 9. Then proceed to step 12. Keep the two
Weight Adapters (19) in a safe place in case you
need them in the future.
Fully engage the indicated hook on both sides of
the weight rack before beginning this step.
Insert a 50mm Bushing (30) into the end of a Weight
Adapter (19). With a second person holding the
Barbell (21) so that it cannot turn, use the allen
wrench to secure the Weight Adapter to the Barbell
with a Large Washer (28) and an M10 x 25mm Button
Head Bolt (27). Note: The Large Washer must fit
into the indentation in the 50mm Bushing in the
Weight Adapter.
Pull the remaining length of the Barbell (21) in the
direction shown. Next, tighten the M8 x 20mm
Screws (33) used in step 9. Attach the other Weight
Adapter (19) to the other end of the Barbell (21) in the
same manner.
19
21
Hook
28
30
27
11
