8
5. Remove the Shock Pin (102) from the lower end of the
Shock (88).
Next, press the lower end of the Shock (88) onto the ball
on the bracket on the Base (83). If necessary, pivot the
Frame (48) slightly and rotate the Shock to align the end
of the Shock with the ball on the bracket.
See drawing 5a. Insert the end of the Shock Pin (102)
into two of the small holes in the end of the Shock (88).
Then, rotate the Shock Pin until it clips onto the Shock.
Carefully lower the Frame (48) to the floor.
88
102
88
102
5
83
48
Bracket
Bracket
5a
6. Remove the elastic band holding the Upright Wire
Harness (75). Insert the Upright Wire Harness (75)
through a Handrail Spacer (95). Press the Handrail
Spacer into the top of the Right Upright (74). Press a
Handrail Spacer into the Left Upright (73).
Have two people hold the console assembly near the Left
Upright (73) and the Right Upright (74). Connect the
Upright Wire Harness (75) to the console wire.
Make sure
to connect the connectors properly (see the inset
drawing); the connectors should slide together easily
and snap into place.
If the connectors do not slide to-
gether easily and snap into place, turn one connector and
try again to connect them.
IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
Insert the Upright Wire Harness (75) and the console
wire into the Right Upright (74). Next, insert the brackets
on the console assembly into the Right Upright and the
Left Upright (73).
Be careful not to pinch the wires.
74
Console
Assembly
73
Console Wire
75
95
6
75
7. Finger tighten three Handrail Bolts (64), with three
Handrail Star Washers (90), into the Right Upright (74)
and console assembly. Repeat with the Left Upright (73).
After all six Handrail Bolts have been started, tighten
the four front Handrail Bolts first before the other
two Bolts.
7
Console
Assembly
90
64
90
73
74
64
