4
Place all parts of the ski exerciser in a cleared area and remove the packing materials; do not dispose of the
packing materials until assembly is completed. Assembly requires only the included flat wrench tool.
A
SSEMBLY
1
3
73
72
2
Hole
1
2
74
76
2
76
1. Align the holes in the Leg Bracket (2) with the holes in
the Front Frame (1). The ends of the Leg Bracket should
angle away from the Front Frame and the indicated hole
should be positioned as shown.
Using the included flat wrench tool, attach the Leg
Bracket (2) to the Front Frame (1) with two 3/8” x 5/8”
Hex Screws (73) and two 3/8” Washers (72).
2.
Slide a Leg (76) into the square opening in one end of
either Leg Bracket (2). Align the second hole from the
bottom of the Leg with the hole in the Leg Bracket.
Insert the straight end of a Leg Pin (74) completely
through the holes in the Leg (76) and Leg Bracket (2).
The bent end of the Leg Pin should point toward the
floor as shown. Make sure that the Leg Pin goes
completely through the holes. Rotate the bent end of
the Leg Pin to secure it in place.
Attach the other Leg (76) in the same manner.
3.
Lift the Upper Body Arm (27) slightly so it does not
catch on the Front Frame (1) as you raise the Upright
(16).
Lift the Upright (16) and lower it into the Front Frame
(1). You will hear it snap into place when it is positioned
correctly. Tighten the Upright Knob (17).
27
16
17
1
