9
7. Identify and orient the Rear Stabilizer (2) as
shown.
Remove the Ramp Cover (not shown)
and set it aside until step 11.
Lift the Ramp (55) and slide the Rear Stabilizer
(2) onto the Frame (1).
Make sure to place the
Ramp on the indicated Rollers (27).
While a second person tips the Frame (1) side-
ways, attach the Rear Stabilizer (2) with four
M10 x 58mm Bolts (84) and four M10 Hex Nylon
Locknuts (103).
Make sure that the Hex Nylon
Locknuts are in the hexagonal holes.
Tip: To prevent squeaking, do not overtight-
en the Bolts.
7
84
103
103
84
27
55
Hexagonal
Holes
Hexagonal
Holes
2
8. Cut and remove the wire tie that holds the Link
Tube (30) inside the left Link Arm (25). Leave
the Link Tube inside the left Link Arm and then
position the Left Pedal Leg (24) and the left Link
Arm as shown.
Apply a small amount of the included grease to
a Barrel Nut (76). Insert the Barrel Nut through
the indicated holes in the Left Pedal Leg (24)
and the left Link Arm (25). Then, insert the
Barrel Nut through the Link Tube (30) inside the
left Link Arm.
Tighten an M6 x 14mm Flat Head Screw (75)
into the Barrel Nut (76).
75
30
76
25
24
Grease
Holes
8
1
